k-26 ? 2014 glenair, inc. series 80 mighty mouse u.s. cage code 06324 printed in u.s.a. .562 (14.27) max .517 (13.13) .003 (0.08) .219 (5.56) .217 (5.51) ?.316 (8.03) .313 (7.95) .033 (0.84) .029 (0.74) .213 (5.41) hex crimp .562 (14.27) max .625 (15.88) .006 (0.15) ?.316 (8.03) .313 (7.95) .033 (0.84) .029 (0.74) ? .0355 .001 (0.90 0.03) .213 (5.41) hex crimp specifcations description requirement nominal impedance 50 ohms frequency range 0 C 2.5 ghz dielectric withstanding voltage 1300 vac sea level, 250 vac at 50,000 feet insulation resistance 5000 megohms minimum durability 500 mating cycles materials, finishes contact body, center contact, ferrule copper alloy contact fnish 50 microinches gold over nickel plating dielectric fluorocarbon coax contacts ft glenair series 80 mighty mouse connectors and mil-dtl-38999 series i, iii and iv connectors with size 8 contact cavities. 50 ohm nominal impedance. 0-2.5 ghz frequency range. solder conductor to center contact is solder type, shield termination is crimp type. supplied as unassembled kit with contact body, center contact, outer ferrule and sealing boot. contacts are snap-in, rear release with plastic extraction tool. gold-plated copper alloy, tefon? insulator. see following page for information on coaxial cable. size #8 50 ohm contacts for low loss high performance coax cable fig. 1 pin contact 852-043 fig. 2 socket contact 852-042 mighty mouse connectors with size #8 quadrax, twinax, coax or power contacts size #8 50 ohm coax contacts 852-042 and 852-043 sealing boot wire dia. (in.) wire dia. (mm.) part number .090 - .130 2.3 - 3.3 859-042-01 .130 - .1f0 3.3 - 4.3 859-042-02 .1f0 - .205 4.3 - 5.2 859-042-03 plastic tool extracts wired contact from connector. first, remove sealing boot, then insert tool from rear of connector. contact removal tool size part number military part number #8 859-049 m81969/14-12 .985 (25.02) max .326 (8.28) .350 (8.89) fig. contact type part number contact only part number contact and sealing boot sealing boot fig. 1 pin 852-043 852-043f 859-042-02 fig. 2 socket 852-042 852-042f 859-042-02 optional sealing boot is recommended. slide boot onto wire before terminating contact. after contact is installed in connector, slide boot forward into connector grommet to seal the contact cavity. "f" sufx on contact part number specifies contact supplied with 859- 042-02 sealing boot. rev. 07.07.15 www.glenair.com e-mail: sales@glenair.com glenair, inc. ? 1211 air way ? glendale, ca 91201-2497 ? 818-247-6000 ? fax 818-500-9912 dimensions in inches (millimeters) are subject to change without notice. mighty mouse with #8 contacts k
k-27 figure part number military part number daniels part number a 809-129 m22520/5-01 hx4 b 859-051 m22520/5-05 y19f a parallel action tool terminates cable shield to contact ferrule. 11 inches oal, 2.0 pounds. anodized aluminum frame, steel mechanism, plastic handles. accepts all m22520/5 die sets. b hex die set for terminating cable shield to contact ferrule. hardened steel, black oxide fnish. termination tools for size #8 50 ohm coax contacts cable information (reference only, not sold by glenair) coax contacts 852-042 and 852-043 are designed for use with llsb-200 cable. this low loss, fexible cable is suitable for shipboard, airframe and tactical vehicles. manufactured by times microwave, this cable is qualifed to mil-dtl-17/220. jacket is non-halogen, low smoke black uv resistant cross-linked polyethylene. terminate inner contact to center conductor of cable with soldering iron. the outer ferrule is terminated to the cable shield with a m22520/5-01 parallel action crimper and a hex die. a b solid bare copper inner conductor polyethelyne jacket tinned copper outer braid shield foamed polyethelyne dielectric core bonded aluminum tape inner shield times microwave part no. llsb-200 military part number m1f/220-0001 impedance 50 2 shielding efectiveness (db) 90 min. conductor diameter .044 (1.12) conductor type bare copper dielectric diameter .118 (3.0) outer shield diameter .144 (3.66) jacket diameter .195 (4.95) weight (lbs/100 ft.) 3f.4 capacitance (pf/ft) 2f.0 velocity of propagation % 80 temperature range -30 to +85c attenuation (db/100 ft) 10 mhz 1.3 100 mhz 3.8 400 mhz f.f 1 ghz 12.0 2.5 ghz 20.0 mighty mouse connectors with size #8 quadrax, twinax, coax or power contacts size #8 50 ohm coax contacts 852-042 and 852-043 rev. 07.07.15 www.glenair.com e-mail: sales@glenair.com glenair, inc. ? 1211 air way ? glendale, ca 91201-2497 ? 818-247-6000 ? fax 818-500-9912 ? 2014 glenair, inc. series 80 mighty mouse u.s. cage code 06324 printed in u.s.a. dimensions in inches (millimeters) are subject to change without notice. mighty mouse with #8 contacts k
|
